Torque specs, Centauro, Daytona RS

The new Centauro, Daytona RS manual has a table of torque specs listed in Kgm (kilogram/meters) to translate to Foot/lbs, multiply by 7.2330139. These are the values I came up with

(Kgm) = ft lbs

Cylinder head studs (4.2 - 4.5) = 30.3-32.5

Frame screws, 8X1.25mm (2.2 - 2.3) = 15.9 - 16.6

Spark Plugs (1.5 - 2) = 10.8 - 14.4

Oil feed banjo bolts10X1.5 (2 - 2.5) =14.4 - 18

Head temp. sensor case (1 - 1.2) =7.2 - 8.6 with locktite 601

Head temp. sensor (1 - 1.2) = 7.2 - 8.6

Air temp. sensor securing screw (.01) = .72

Connecting rod cap screws, Carillo (8.5 - 9.3) = 61.4 - 67.2

Flywheel to crankshaft, 8X1.25mm (4 - 4.2) = 28.9 - 30.3

Ring gear to fly wheel, 8X1.25mm (3) = 21.6

Crank shaft pinion, 25X1.5mm (11 - 12) = 79.5 - 86.7

Alternator nut, 16X1.5mm (9 -9.5) = 65 - 68.7

Nut "service shaft pulley" 16X1.5mm (10 - 12) = 72.3 - 86.7

Nut cam shaft pulley 14X1.5mm (6 - 7) = 43.3 - 50.6

Nut oil pump gear 8X1mm (2 -2.2) = 14.4 - 15.9 with locktite 601

Pressure control valve 14X1.5 (6 - 7) = 43.3 - 50.6 with locktite 601

Nut, locking, secondary shaft (16 - 18) = 115.7 - 130.1

Fill plug, tranny, drive box (3) = 21.6

Level and drain plug, tranny, drive box (2.5) = 18

Safety nut, secondary shaft (7 - 8) = 50.6 - 57.8

Pinion nut, drive box (18 - 20) = 130.1 - 144.6

Ring gear screws, drive box (4 - 4.2) = 28.9 - 30.3

Screw, sidestand support (7 - 7.5) = 50.6 -54.2

Rear Axle, case side screw (12) = 86.7

Front Axle (9 - 10) = 65 - 72.3

Brake disk screws (2.8 - 3) = 20.2 - 21.6 with locktite 270

Standard settings

4mm (.3 - .35) = 2.1 - 2.5

5X0.8mm (.6 - .7) = 4.3 - 5

6X1mm (.8 - 1.2) = 5.7 - 8.6

8X1.25mm (2.5 - 3) = 18 - 21.6

10X1.5mm (4.5 - 5) = 32.5 - 36.1

Back to Archival Stuff page